SAE J2716 (SENT) to CAN Gateway

£230.00

A bus gateway featuring two bi-directional SENT (Single Edge Nibble Transmission) channels, two analogue output channels, and a CAN bus interface. The interface’s flexibility allows the user to use it as a PC interface / SENT data logger, a gateway for PLC or a test system, and generally for SENT communication monitoring and simulation. The analogue outputs offer the possibility to directly convert SENT data frame signals into an analogue voltage.

Description

A low-cost gateway between two SAE J2716 (SENT) channels and a CAN bus. The device features two bi-directional SENT channels and a CAN bus interface. Fast, Short Serial, and Enhanced Serial message formats are supported.

For More information:

SENT-RS232_CAN-Gateway-Data-Sheet

  • SENT-to-CAN Gateway
  • SENT logger/tester/simulator
  • Two independent SAE J2716 (SENT) channel
  • Each channel configurable as RX or TX
  • Supports Fast and Slow Messages according to SAE J2716:2016 (Fast, Short Serial, and Enhanced Serial)
  • Supports SENT/SPC
  • Configurable SENT channel parameters – Tick Time, Nibble Count
  • 2 analogue output channels (12-bit DAC, 0-4,095 V)
  • On-board remanent memory
  • Intelligent message filtration
  • 1x DSUB9F (CAN), 1x 8-pin terminal block
  • Input power 9-30 V DC
  • 4x LED (3x Status, 1x Power)
  • 1x Reset switch
  • 5V DC output with over-current protection
  • Dimensions 108 x 54 x 30 mm
  • Table or DIN-rail mount
  • Hardware and firmware customization on request