SENT to CAN Kit

£499.00

The kit comes with:

  • X-Analyser 3 Standard with Signals/CAN database editor and OBD capabilities.
  • Kvaser Leaf LIN to USB interface
  • SENT-to-CAN Interface

 

Kvaser Leaf Light CAN-HS v2

Kvaser Leaf Light CAN-HS v2 – This single CAN channel interface represents one of the easiest and lowest-cost methods of connecting a computer to a CAN bus network. It has a USB 2.0 compliant connector with a 9-pin D-SUB connector. Galvanic isolation as standard. Recommended for use with the X-Analyser 3.

IN STOCK

For Technical Data open the pdf below.

Kvaser Leaf Light CAN-HS v2

WCT Kit Bag small laptop

Neoprene bag for carrying your portable tech

SAE J2716 (SENT) USB Interface

X-Analyser 3 Standard Edition (Single Channel)

X-Analyser 3 Standard Edition (Single Channel) – This has all the functions of the ECO with the addition of CAN data base (dbc) and LDF capability. The Standard is single CAN or LIN channel only – dongled from the Kvaser interface serial number. For feature comparison with other versions of X-Analyser 3, please see:

X Analyser  Features

Free Software Resources

Categories: ,

Description

The kit comes with:

  • X-Analyser 3 Standard with Signals/CAN database editor and OBD capabilities.
  • Kvaser Leaf LIN to USB interface
  • SENT-to-CAN Interface

A low-cost gateway between two SAE J2716 (SENT) channels and a CAN bus. The device features two bi-directional SENT channels and a CAN bus interface. Fast, Short Serial, and Enhanced Serial message formats are supported.

For More information:

SENT-RS232_CAN-Gateway-Data-Sheet

  • SENT-to-CAN Gateway
  • SENT logger/tester/simulator
  • Two independent SAE J2716 (SENT) channel
  • Each channel configurable as RX or TX
  • Supports Fast and Slow Messages according to SAE J2716:2016 (Fast, Short Serial, and Enhanced Serial)
  • Supports SENT/SPC
  • Configurable SENT channel parameters – Tick Time, Nibble Count
  • 2 analogue output channels (12-bit DAC, 0-4,095 V)
  • On-board remanent memory
  • Intelligent message filtration
  • 1x DSUB9F (CAN), 1x 8-pin terminal block
  • Input power 9-30 V DC
  • 4x LED (3x Status, 1x Power)
  • 1x Reset switch
  • 5V DC output with over-current protection
  • Dimensions 108 x 54 x 30 mm
  • Table or DIN-rail mount
  • Hardware and firmware customization on request